[TRNSYS-users] Storage Tank 3 In/Outlets

[Ökoplan Frau Settler]

Hello TRNSYS users,

 

I am searching for a thermal storage tank model (vertical, cylindrical) with
three inlets and three outlets, similar to Type 4 or Type 60. 

Where can I find one? 

 

Best Regards,

 

Sarah

 

 

 

Mit freundlichem Gruß,

 

Sarah Settler

 

 

Ökoplan

Büro für zeitgemäße Energieanwendung

Hummelsbütteler Weg 36

22339 Hamburg

T 040 5394143 F 040 5394144

 

  _____  

Von: knut.erik.enerstvedt at niva.no [mailto:knut.erik.enerstvedt at niva.no] 
Gesendet: Dienstag, 22. September 2009 09:22
An: coalespr at btinternet.com
Cc: trnsys-users at cae.wisc.edu
Betreff: Re: [TRNSYS-users] How many zones?

 


Paul, 

The easiest way is to use two zones, but if the thernostat is in the hall,
maybe you should include that zone as well? You can also consider using
CONTAM or COMIS to calculate air exchange between the zones, although this
makes it more complicated. 

You can have one emitter for each zone. To represent parallell heating
circuits, just split the total flow from the heat pump using a diverting
valve component (Hydronics library) into one stream for each emitter and
then, after the emitters, combine the streams again using a mixing valve
component and connect it back to the heat pump. 

Kind regards, 
Knut Erik   




From: 

trnsys-users-request at cae.wisc.edu 


To: 

trnsys-users at cae.wisc.edu 


Date: 

09/18/2009 02:24 PM 


Subject: 

TRNSYS-users Digest, Vol 57, Issue 31

 

  _____  




----- Message from PAUL COALES <coalespr at btinternet.com> on Fri, 18 Sep 2009
08:25:48 +0000 (GMT) ----- 


To:

trnsys-users at cae.wisc.edu 


Subject:

[TRNSYS-users] How many zones?

 


I am modelling a 2-floor domestic property.  The 2 floors are connected by
an open hall, stairs and landing.  A thermostat is located in the hall.

A single heating system (GSHP) will need to supply heat to both floors
(under floor heating or low temperature radiators.)

What is the easiest way of modelling this;  I'm thinking:

1) Use 2 zones;  One for upstairs and one for down stairs.
2) Each zone has an emitter.
3) Each emitter is a load on the same heating system.  Is it easy to
represent parallel heating circuits from a single heat source?  What
components should I be looking at?

Any comments welcome. 

Thanks 

Paul







----------------------------------------------------------------------------
--------------------------------
Meld deg på vårt nyhetsbrev på www.niva.no

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20090922/d8857123/attachment-0001.htm>