[TRNSYS-users] Type-2b??? (part2)

[Francois Badinier]

Francesco

 

Sorry I just missed one thing:

-          You have to set your “lower input temperature” to 20.5, as it is
now your fixed temperature to compare with.

I forgot to do that in the modified project... sorry my bad.

 

However, you’ll see that the signal won’t go to 0 when it reaches 22 C (in
your schedule), as it has to strictly go over 22 for the signal to switch to
0. So if you put in your schedule 23C instead of 22C, you’ll see the signal
switching.

 

Regards,

 

François Badinier

Development Engineer

ICAX Ltd

1 Hatfield House 

Baltic Street West

London EC1Y OST

 <mailto:alan.kiff at icax.co.uk> francois.badinier at icax.co.uk

 <http://www.icax.co.uk> www.icax.co.uk

 

 

 

-----Original Message-----
From: Besana Francesco [mailto:Francesco.Besana at eurac.edu] 
Sent: 25 November 2009 11:06
To: trnsys-users at cae.wisc.edu
Subject: [TRNSYS-users] Type-2b???

 

Dear Trnsys-colleague,

It is unbelievable but I have spend more than one hour on that and still
doesn't work...the point is:

 

I would like to switch off a signal when the difference between the High
Temp (fix to 22 ) and Low Temp is less than 0 and switch on again when the
difference is higher than 1.5..are you able to do that?

 

At the moment in my deck (attached) it seems that instead off an hysteresis
loop I have just a value limit 1.5 where is ON and OFF around it!!!

 

Thanks a lot and suggestions are well accepted

 

Francesco

   

 

No virus found in this incoming message.

Checked by AVG - www.avg.com 

Version: 9.0.709 / Virus Database: 270.14.80/2523 - Release Date: 11/25/09
07:31:00

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20091125/abe3210b/attachment-0005.htm>