[TRNSYS-users] Heating pipes model

knut.erik.enerstvedt at niva.no knut.erik.enerstvedt at niva.no
Tue May 12 02:47:49 PDT 2009


Dear TRNSYS users,

I need to model heating pipes commonly found in greenhouses. The pipes are 
in loops located 15 cm above the floor, 1 m above the floor, along the 
walls and somewhat below the ceiling. Hot water flows in the pipes and 
heats up the greenhouse. I use Type 56 to model the greenhouse, but have 
not yet succeded in finding a model for the heating pipes. Does anyone 
know an appropriate model for the heating pipes and how to use it in 
combination with Type 56? 

I have considered using active layers, but then again the pipes are not 
actually inside the floor or walls.

Best regards,
Knut Erik Enerstvedt


------------------------------------------------------------------------------------------------------------
Meld deg på vårt nyhetsbrev på www.niva.no
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20090512/510e7da2/attachment-0005.htm>


More information about the TRNSYS-users mailing list