[TRNSYS-users] Type 55

[David Bradley]

Arnaud,
 There are a number of parameters in Type55 that allow you to use it to 
watch (and integrate, etc.) what is happening only during certain 
periods of the day. For example, you could set its parameters so that 
you are looking at the min and max that occur between 10am and 2pm each 
month in your building. Make sure that you have those parameters all set 
so that they look at the building over the entire month, not just for 
some portions of the month.
Kind regards,
 David


A.Thome-08 at student.lboro.ac.uk wrote:
> Good afternoon everyone,
>
> In my model, I use type 55, connected to type 56, to have some statistic on
> the temperature variation in the rooms of the building (min, max, mean,
> standard deviation).
>
> However, for on period (a month), the result that type 55 give me and the
> temperature that I can read when I run the simulation on TRNEXE does not
> give me the same result. (different minimum, maximum...)
>
> It is like the type 55 was not doing very fine record of the temperature. Is
> there anywhere I can set the accuracy of type 55?
>
>
> Best regards,
>
> Arnaud.
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
>
>
>
>   

-- 
***********************************************************************
Thermal Energy System Specialists (TESS), LLC 
David BRADLEY                      22 N. Carroll Street - Suite 370 
Partner                            Madison, WI 53703 
                                   USA
P: +1.608.274.2577 
F: +1.608.278.1475
E-mail: bradley at tess-inc.com 
Web Pages:  http://www.tess-inc.com    and      http://www.trnsys.com

***********************************************************************