[TRNSYS-users] creation of new type bis

Technical Support TechSupport at tess-inc.com
Tue May 6 07:55:03 PDT 2008


Dear Seck,
  I would suggest that you launch your simulation not from the TRNSYS Simulation Studio but from your Fortran compiler (select Debug: Go or press F5); you should be asked for the name of an input file (*.dck) to run. You can then step line by line through your code and see why all of the outputs are being set to zero.
Kind regards,
 David





Technical Support TeamThermal Energy System Specialists, LLC2916 Marketplace Dr, Suite 104Madison, WI 53719techsupport at tess-inc.com

----- Original Message -----

Subject: [TRNSYS-users] creation of new type bis

From: "SECK CHEIKH" >;cheikh021979 at yahoo.fr>

Date: Tue, May 6, 2008 4:01




Hi everybody,
I previously needed help about a "Range check error"for my new type after your help this problem is solved.However when i run a simulation there is no errors but all outputs are zero.
Does somebody have an idea?
Kind regards
 __________________________________________________Do You Yahoo!?En finir avec le spam? Yahoo! Mail vous offre la meilleure protection possible contre les messages non sollicités
http://mail.yahoo.fr Yahoo! Mail 

_______________________________________________TRNSYS-users mailing listTRNSYS-users at engr.wisc.edu
https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20080506/d0d787e8/attachment-0001.htm>


More information about the TRNSYS-users mailing list