[TRNSYS-users] Getting error information when running own created component
David Bradley
bradley at tess-inc.com
Mon Jun 30 09:17:05 PDT 2008
Chun Kwong,
Your Type can call the subroutine "MESSAGES()." Please refer to the
08-Programmer's Guide for information on calling and passing information
to MESSAGES()
Kind regards,
David
h8304506 at hkusua.hku.hk wrote:
> Dear all.
>
> I have created a new component in which the simulation will stop if an
> instability is detected. Please advise how I can pass an error
> message out (to screen or to the output file) when this occurs. Thank
> you!
>
> Best Regards
> LEE, Chun Kwong
> PhD student
> Department of Mechanical Engineering
> University of Hong Kong
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
>
--
***********************************************************************
Thermal Energy System Specialists (TESS), LLC
David BRADLEY 2916 Marketplace Drive - Suite 104
Partner Madison, WI 53719
USA
P: +1.608.274.2577
F: +1.608.278.1475
E-mail: bradley at tess-inc.com
Web Pages: http://www.tess-inc.com and http://www.trnsys.com
***********************************************************************
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20080630/5c17085f/attachment-0001.htm>
More information about the TRNSYS-users
mailing list