[TRNSYS-users] Type 56 , active Layers

[John Bisgrove]

Are active layers required to have fluid flowing always at minimum, or only
when non-zero?

I am receiving an error :
Specific fluid mass flow of active layer in surface 26 below minimum value
of 2.87 kg/m^2.h Please increase the minimum mass flow rate or use the
autosegmentation feature of TRNBuild for subdividing the surface.

I have checked the active layer, it won't auto-segment > 1 
And the listed min allowed inlet mass flowrate is listed as 3.57 kg/m^2.h
not the 2.87 kg/m^2.h given in the error message.

I multiplied the area of each floor times the min flow rate for the zone
And set it as an alternative flow, but I still get the ame error.

Thanks for any ideas.

John Bisgrove
Earth Sensitive Solutions
7523 County House Road
Auburn, NY 13021
(315)253-3779
-----Original Message-----
From: trnsys-users-request at cae.wisc.edu
[mailto:trnsys-users-request at cae.wisc.edu] 
Sent: Tuesday, December 09, 2008 1:03 PM
To: trnsys-users at cae.wisc.edu
Subject: TRNSYS-users Digest, Vol 48, Issue 13

Send TRNSYS-users mailing list submissions to
	trnsys-users at cae.wisc.edu

To subscribe or unsubscribe via the World Wide Web, visit
	https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
or, via email, send a message with subject or body 'help' to
	trnsys-users-request at cae.wisc.edu

You can reach the person managing the list at
	trnsys-users-owner at cae.wisc.edu

When replying, please edit your Subject line so it is more specific
than "Re: Contents of TRNSYS-users digest..."

No virus found in this incoming message.
Checked by AVG - http://www.avg.com 
Version: 8.0.176 / Virus Database: 270.9.15/1838 - Release Date: 12/8/2008
6:16 PM

No virus found in this outgoing message.
Checked by AVG - http://www.avg.com 
Version: 8.0.176 / Virus Database: 270.9.15/1838 - Release Date: 12/8/2008
6:16 PM