[TRNSYS-users] Problems with "Cooling" in TYPE 56

[Arie Kalkman]

Dear Bernd,

Yor results are highly unusual, so it is difficult to give any help.

I wonder what the result would be if you switch the cooling to OFF?


Regards,
 
Arie 
--------------------------------------------------------------

-----Oorspronkelijk bericht-----
Van: trnsys-users-bounces at engr.wisc.edu
[mailto:trnsys-users-bounces at engr.wisc.edu] Namens bdo at stb.rwth-aachen.de
Verzonden: maandag 15 januari 2007 10:33
Aan: trnsys-users at engr.wisc.edu
Onderwerp: Re: [TRNSYS-users] Problems with "Cooling" in TYPE 56

Thank you for the reply, perhaps I have not described the problem 
exactly, so your answer does not match my problem. I try it again:

I have created a BUI-file without (!) a heating, only a cooling is 
installed.

But in the results I have values also for heating (in QSENS and in 
QHEAT), although there is no heating installed! Now I have tested 
another model and I get the same surprise: Heating energy demand > 0 
without any heating installed. The amount is lower than in the modell I 
have tested a few days ago, but in my thinking it must be zero.

Thanks for any comments.


Regards,

Bernd.


>
>
> Hi,
>  
> have look to this thread:
>  
> "
>    The Type56 output called QSENS is a positive value when there is a
> cooling load and a negative value when there is a heating load in a given
> zone. QCOOL and QHEAT are the same loads but are split apart so that
> heating load is not a negative number. At any point in time during which
> there is a cooling load QSENS and QCOOL should be equal. At any point in
> time during which there is a heating load QSENS should be the negative of
> QHEAT.
> "
>  
> Dear TRNSYS-users,
>  
> we have created a single zone model of a room, containing a cooling, but 
> no heating is implemented.
>  
> Now I have the problem, that in the output-file I get positve and 
> negative Values for QSENS (and also values for QHEAT in ntype 30). Who 
> has an idea what happens here? Additionally, if I limit the maximum 
> cooling power, the limitation sometimes works, and sometimes I get much 
> higher cooling power demand. What is it, I am really in desperation.
>  
>  
> Best regards,
>  
> Bernd.
>  
>  
>
>  
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users


-- 
**************************************************************
*
*  Dipl.-Ing. Bernd Döring
*  Lehrstuhl für Stahlbau
*  Mies-van-der-Rohe-Str. 1
*
*  52074 Aachen
*
*  Tel.:      ++49 (0)241 80 25180
*             ++49 (0)241 80 25177
*
*  Fax:       ++49 (0)241 80 22140
*
*
*  http://www.stb.rwth-aachen.de
*  http://www.stb.rwth-aachen.de/Mitarbeiter/doering.html
*
**************************************************************


_______________________________________________
TRNSYS-users mailing list
TRNSYS-users at engr.wisc.edu
https://www.cae.wisc.edu/mailman/listinfo/trnsys-users