[TRNSYS-users] data reader

[Michaël Kummert]

Thibaut,
> 
> I want to read data from this file:
>     1    1      1   2.7   0.0041    0  1.00   160
>     1    1      2   2.7 0.00415    0  1.33   173
>     1    1      3   2.5 0.00409    0  1.67   187
>     1    1      4   2.3 0.00408    0  2.00   200
>     1    1      5      2 0.00403    0  2.33   197
>     1    1      6   1.8 0.00397    0  2.67   193
>      ....
> The problem comes with the 5th line, where there is 2 instead of 2.0. 
> when I read it, I get 0.2. The data card I use is:
> (19X,F5.1,....). I can't see the solution, and I can't replace it 
> because there are a lot of that cases in my file.
> 

You do not need to specify a read format in TRNSYS, as long as there is 
at least one blank character (space, tab) between all the numbers on the 
same line.
I tested your file with Type 9 in free format and it seems to work fine 
(see attached project). I used Type 9 in mode 5 (Type9c) and I assumed 
all data were averaged over one hour so you may have to make a few 
changes to Type 9's configuration if my assumption is not correct.

I hope this helps,

Michaël Kummert


--
_________________________________________________________________

Michaël Kummert

École Polytechnique de Montréal - Dept. of Mechanical Engineering
PO Box 6079, stn. Downtown
Montréal, QC   H3C 3A7
Canada

Tel: +1 (514) 340-4711, Ext. 5870 (*** NEW PHONE NB. ***)
Fax: +1 (514) 340-5917
Email : michael.kummert à polymtl.ca
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Type9Test.zip
Type: application/zip
Size: 16422 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20060324/98301822/attachment-0005.zip>