[TRNSYS-users] pausing trnsys after each timestep

[Diego A. Arias]

Dear Michel,

I am afraid that this is not possible in TRNSYS.  But there is the 
option for TRNSYS to call a program and wait until it finishes the 
calculations.  You can use the utility subroutine CALLPROGRAM (Volume 
8-Programmer's Guide, section 8.4.4.1) for this purpose.
I hope this helps.
Best regards,

Diego



michel.haller at solarenergy.ch wrote:

> Hello
>  
> I'm trying to run TRNSYS from LabVIEW, and I intend to pause TRNSYS 
> after each simulation timestep until LabVIEW decides that it should 
> calculate the next timestep. Starting TRNSYS is no problem - it can be 
> done with a command line call from LabVIEW, but does anyone have an 
> idea how to tell TRNSYS to pause after every timestep until it get's a 
> call to go on?
>  
> Thanks for helping...
>  
> Sonnige Grüsse
> Michel Haller
> ------------------------------------------------------------------------
> *Michel Haller*
> Systemtechnik / System Division
> Institut für Solartechnik SPF: Adresse 
> <http://www.solarenergy.ch/spf.php?lang=de&fam=44&tab=3> / Website 
> <http://www.solarenergy.ch/spf.php?lang=de&fam=41&tab=1>
> Hochschule für Technik Rapperswil HSR
> Tel. +41 55 222 48 29
> Fax +41 55 222 48 44
> ------------------------------------------------------------------------
>  
>
>------------------------------------------------------------------------
>
>_______________________________________________
>TRNSYS-users mailing list
>TRNSYS-users at engr.wisc.edu
>https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
>  
>


-- 

Diego A. Arias
TRNSYS Coordinator
Solar Energy Laboratory
University of Wisconsin - Madison
1500 Engineering Drive
Madison, WI 53706