[Hap-users] help

[varun kulkarni]

Anant,

How much I understand from your sanpshot and questions, is that you just one
zone and you are supplying 58 F air to it from the air handler.
>From the limited information I can see here, you might be able to check the
following:
1) Supply air temperature to the zone. This may be the reason why you have
unmet load hour.
2) Check your themostat set points and throttling range.
3) See the system simulation results (unmet load report) to see that your
units is undersized.

let me know if this works, or if it doesnt, would need more information.

On Mon, Mar 28, 2011 at 10:05 AM, Ananth K <ananth.k at pace-kuwait.com> wrote:

>
>
> 1.       Why the zone T-stat check says 0 of 1 OK, can’t the software fix
> this by itself?
>
> 2.       When I change the thermostat unoccupied to 85 deg F then this
> deviation increases to 8.5 deg F!!
>
> 3.       The throttling range is 0.1 deg F.
>
> _______________________________________________
> Hap-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/hap-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> HAP-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>


-- 

Thanks and Best Regards,



Sincerely,

Varun Kulkarni , M.S. , EIT

RMF Engineering

5520, Research Park Drive, Suite 300

Baltimore, MD - 21228



Office : 410-576-0505 ext. 5352

Mobile: (+1)405-385-1928



Note: Please do not print, unless required.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/hap-users-onebuilding.org/attachments/20110328/49281aa6/attachment-0002.htm>