[Equest-users] Importing PDF in eQUEST 3.65

[Sharad Kumar via Equest-users]

Hi equest users,

You can have only ortho or without ortho command to have a geometry in
AutoCAD.
This you can do easily by enlarging the PDF image by stretching in the CAD
file.
You will have to consider the unit of the PDF file like as it was in
millimeter or meters in SI unit or Indian cases.
Similarly if the PDF file has a width of 2.5 feet and the length of the
line in that door width is 0.7459. Then in any case you will have to put
2.5/0.7459=3.351655 in the 1 CAD unit and take feet as the unit in that
case as and at there where it was meters in the previous one.
This means that the PDF file image having CAD file has a width of 0.7459
for example for the same original width of 2.5 feet for that door.
So just for example take the unit as same in PDF and the division of both
the line in AutoCAD on door and the original width of the door to have a
work with the units of PDF.


*Thanks,*
Sharad.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20161117/c3948404/attachment-0001.htm>