<div dir="ltr"><font color="#20124d">Hi equest users,</font><div><font color="#20124d"><br></font></div><div><font color="#20124d">You can have only ortho or without ortho command to have a geometry in AutoCAD.</font></div><div><font color="#20124d">This you can do easily by enlarging the PDF image by stretching in the CAD file.</font></div><div><font color="#20124d">You will have to consider the unit of the PDF file like as it was in millimeter or meters in SI unit or Indian cases.</font></div><div><font color="#20124d">Similarly if the PDF file has a width of 2.5 feet and the length of the line in that door width is 0.7459. Then in any case you will have to put 2.5/0.7459=3.351655 in the 1 CAD unit and take feet as the unit in that case as and at there where it was meters in the previous one.</font></div><div><font color="#20124d">This means that the PDF file image having CAD file has a width of 0.7459 for example for the same original width of 2.5 feet for that door.</font></div><div><font color="#20124d">So just for example take the unit as same in PDF and the division of both the line in AutoCAD on door and the original width of the door to have a work with the units of PDF.</font></div><div><font color="#20124d"><br></font></div><div><font color="#20124d"><br></font></div><div><font color="#660000"><b>Thanks,</b></font></div><div><font color="#4c1130">Sharad. </font></div><div><br></div></div>