[BLDG-SIM] Stack Effect Calculations
Jinchao Yuan
jcyuan at MIT.EDU
Wed Aug 22 11:10:05 PDT 2007
Kevin,
ContamW can be used for this purpose but you need
to prescribe the temperatures since ContamW will
not simultaneously compute the temperatures for
you. It is especially useful if you used
mechanical systems in the building and you have
some estimation about the atrium temperature
distributions. If you need to compute the zonal
temperatures and infiltration airflow
simultaneously, a better solution is to use
Transys---which includes the multi-zone airflow
module of ContamW, I believe---to coupled airflow and thermal simulation.
Jinchao
At 01:11 PM 8/22/2007, Kevin Burke wrote:
>Dear All,
>
>Im currently looking at problems which may
>arise due to stack effect in a high rise mixed
>use building in London. Although most tall
>buildings these days have relatively good air
>tightness the proposed building will have the
>possibility of air penetrating the office
>façades from about 20m to 100m (70ft to 330ft)
>and again where there is apartments from 180m to
>230m (600ft to 760ft). It is also possible that
>significant infiltration will occur at the top
>of the building. A number of lift shafts and
>stairwells under worst case situations allow
>this air to travel the full or close to the full height of the building.
>I have found a number of papers which discuss
>this topic but I havent come across a means of
>quickly estimating worst case scenario pressure
>differences for individual lift shaft or
>stairwells. Does anyone know of a calculation
>tool or similar which could do this. I have
>downloaded a program called COMTAMW. Does anyone
>know if this is a useful programme for proposed
>buildings where all the parameters are not know and may have to be estimated?
>
>Kind Regards,
>
>Kevin Burke
>
>
>
>
>____________________________________________________________
>Electronic mail messages entering and leaving Arup business
>systems are scanned for acceptability of content and viruses
>
>
>
>
>You received this e-mail because you are subscribed
>to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
>from this mailing list send a blank message to
>BLDG-SIM-UNSUBSCRIBE at GARD.COM
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20070822/14d35c6f/attachment.htm>
More information about the Bldg-sim
mailing list