[TRNSYS-users] error when importing trnsys 3d- model in simulation studio

[Brian Raichle]

Hi Jorn,
I've seen this error when there's a line left, for example if you deleted a
surface but didn't delete all the borders (the ones on top of other borders
are tough!). Maybe that's it.
Best,
Brian

On Sun, Mar 24, 2013 at 4:13 PM, Jorn Ostijn <jorn.o at vkgroup.be> wrote:

>  Hey everyone,
>
> When making a 3D Building project (multizone), I encountered an error when
> trying to open my .idf-model (google sketchup).
> The error is the following:
> "At least 2 surfaces are required per zone!"
>
> What 's weird about this error, is that I can not find a zone consisting
> of less than 2 surfaces + I can't find "surface -1" in my model.
>
> I searched but have not been able to solve this error yet.
> Is anyone familiar with this error? Where lies the problem?
> You can find my .idf-model in annexe.
>
> Thank you very much for helping me out,
>
> Jorn Ostijn
>
> Project engineer
> VK Engineering
>
>
>
>
>
> * SUBSCRIBE TO OUR E-LETTERS **   * click here <http://’>
>
> ****DISCLAIMER****
> This communication is confidential and for the sole useof the addressee.
> If you are not the intended recipient,
> please immediately notify the sender by e-mail at the address shown and
> then delete it from your system
> without copying, disclosing or forwarding its contents. Thank you.
>
>
>
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users
>
>


-- 
Brian Raichle
Department of Technology and Environmental Design
Appalachian State University
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20130324/8468fb13/attachment-0005.htm>