[TRNSYS-users] range check error

[mcdowell at tess-inc.com]

Emanuele - 

A range check error is a generic FORTRAN error that can
be difficult to diagnose, but is usually caused by a divide by zero.


TRNSYS version 16 was replaced by version 17 in 2009 and is no longer
supported. But if you send me your project files I will take a quick
look and see if I can determine the cause of the error. 

Regards, 

Tim


---
Timothy P. McDowell
Executive Vice President
Thermal Energy System
Specialists, LLC
22 N Carroll St, Suite 370
Madison, WI
53703
608-274-2577

On 2013-03-18 11:02, Emanuele Santovito wrote: 

>
Hi, 
> I'm a student of mechanical engineer in Rome, I'm using Trnsys
studio 16 to simulate what happens to the internal temperature of a
urban bus during the hot summer when there is the opening and closing of
the doors at the stops. I have created a schedule in which every 5
minutes there is a change of air for 1 minute from the 3 doors of the
bus. The problem is that for every different type of schedule (a stop
every 6,7,8,10 minutes) the program doesn't run over one hour... I need
to see what happens from 12 pm to 15 pm (the most hot hour of the day)
but the program run only from 12 to 13 pm and then stops saying "range
check error"... the only setup tha works good in 3 hours is setting a
stop of one minute every 20 minute... but it is not realisti 20
minutes... So I need the way to make work good the program with a stop
of one minute every 5 minutes for 3 hours. 
> I hope to have been clear
in telling about this problem...If you can help me it would be great!
thanks for the attention! 
> 
> Best regards, 
> 
> Emanuele Santovito
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20130319/2ec089d3/attachment-0005.htm>