<div dir="ltr"><div dir="ltr"><div dir="ltr"><div dir="ltr"><div dir="ltr"><div dir="ltr"><div dir="ltr"><div dir="ltr"><div>Dear TRNSYS users,</div><div><br></div><div>Hi,</div><div><br></div><div>I have created a 3-zone building using Trnsys3d, and then imported the generated IDF file into Simulation Studio. During my efforts to modify the building model in the TRNBuild environment, I noticed that the wall areas of the zones (in TRNBuild) were not the same as those on the sketchup software. Despite this, the floors have the same area. As an example, the south wall area on sketchup and TRNBuild is 30 m*2 and 3.75 m*2 respectively, but the floor area is 113 m*2 on both software.</div><div>I would appreciate any assistance in solving my problem.<br></div><div><br></div><div>Best Regards,</div><div>Ali</div></div></div></div></div></div></div></div></div>