<div dir="ltr">Hello,<div><br></div><div>I am modeling a variable speed water to water heat pump using the multi dimensional interpolator, and I want to be able to change the setpoint of the heat pump. Currently, I am reading the return temperature and inlet flow rate, and inputting that into an equation to calculate the load necessary to have my output equal to my desired setpoint temperature. I am controlling the setpoint temperature based on an equation that defines time periods when it should be higher or lower. </div><div><br></div><div>My issue is, during transitional periods for the setpoint, there is a steep increase/decrease in temperature, which I cannot reconcile based on the loads seen by the heat pump. Any advice on how to fix this, or a better strategy to implement my needs? Any help would be greatly appreciated</div><div><br></div><div>Thank you,</div><div>Erich Ryan</div></div>