<div dir="ltr"><p class="MsoNormal" style="margin:0cm 0cm 8pt;line-height:107%;font-size:11pt;font-family:Calibri,sans-serif">Hi everybody,</p>

<p class="MsoNormal" style="margin:0cm 0cm 8pt;line-height:107%;font-size:11pt;font-family:Calibri,sans-serif"> I'm trying to model a
radiant system in which the return flowrate of the radiant is recirculated. I’m
using type 11b to divide the return flowrate into 2 parts so that the
temperature at the inlet of the radiant system is constant at 31 ° C. A part of
the flowrate out of the type11b is recirculated and a part is heated in a tank
and subsequently mixed in the type 11h with the recirculated flowrate. After
the type11h I have a constant flowrate pump (type114) and then I have the
radiant system to which I apply a negative delta_T. The flowrate out of the
radiant is sent to type11b. Having applied a negative delta_T the temperature
at the inlet of type 11b is lower than 31 ° C but trnsys gives me this error
message: "The inlet temperature and the heat source temperature have
simultaneously exceeded the set point temperature. Gamma has been set to 0
(Mode 4) or 1 (Mode 5) ". I tried to simulate the same system with the
type 115 but I have the same problems. If I simulate an open loop system such
as a domestic hot water system I haven't errors. I have errors in case i
simulate a closed loop system where recirculated water is required.</p>

<p class="MsoNormal" style="margin:0cm 0cm 8pt;line-height:107%;font-size:11pt;font-family:Calibri,sans-serif">Basically the system is the same as that of page 4-328
(component mathematical reference) figure 4.5.2-4 with the difference that the
to-load and the make-up are united (same flowrate but different temperature),
but the to-load temperature is higher than the make -up beacause of I apply a
delta_t through a calculator (equa) beetwen to-load and make-un. I hope you can
help me.</p>

<p class="MsoNormal" style="margin:0cm 0cm 8pt;line-height:107%;font-size:11pt;font-family:Calibri,sans-serif">Best regards </p></div>