<div dir="ltr"><br><div>Dear TRNSYS users,</div><div><br></div><div>I have a simulation where I feed varying temperature setpoints and constant powers to Type56 in order to control each thermal zone's temperature using the built-in Heating Type Manager. </div><div>I noticed that the zones' temperature does not reach the given temperature setpoint sometimes although the power used (that is, Type56's output Qsens) is lower than the given power. </div><div>This phenomenon happens only during the first time step, when the given temperature setpoint goes from 16°C to 19°C. </div><div>I ran the simulation with unlimited sensible heating power, but I still had the same problem. </div><div>The simulation runs with a 10 min time-step. </div><div>Do you have any suggestions?</div><div>Thank you very much!</div><div><br></div><div>Best regards,</div><div><br></div><div>Anthony</div></div>