<div dir="ltr"><div>Dear All,</div><div><br></div><div>I have desgined in SketchUP a single thermal zone with 3 airnodes placed on different heights (<i>10</i>, <i>60</i>, <i>110</i> cm). I used a <i>Virtual Surface</i> option to model the surfaces which, after exporting them to TRNBuild, could dissapear. <br></div><div><br></div><div>In my simulation of the zone, I would like to obtain three values of Tairnode, Toperative and mean radiant temperature for each airnode. Unfortunately, when I perform simulation in TRNSYS, all three values of mean radiant temperatures are the same. This I did with the radiation model set to <i>standard</i>.</div><div><br></div><div>When I am trying to use the <i>detailed</i> radiation model, I got two error informations:</div><div><br></div><div><b>-</b> ==== zone GROUND_FLOOR_10... ... ERROR in summing view factors of surface 4. Please check geometry!!!.</div><div><br></div><div><b>-</b> Error while creating VFM file.<br>+++ Note: Zones have to be convex and closed volumes.<br>          Surfaces must have an outwarding normal.</div><div><br></div><div>This causes the situation that I am unable to open the .vfm file in TRNSYS and cannot get the mean radiant temperature values.</div><div><br></div><div>I assume that the problem is caused by the fact that my model might not be a closed volume, due to the virtual surfaces I have created in SketchUP. So my question is, is there another way to get the MRT values for each airnodes separetely? <br></div><div><br></div><div>The view factor of <i>surface 4</i> is set to 0.5 automatically, as it is one of the vertical walls.<br></div><div><br></div><div>Thank you in advance for your help.</div><div><br></div><div>Kind regards,</div><div>Lukasz Watly<br></div><div><br></div></div>