<div dir="ltr"><div><div><div><div><div><div><div><div>Dear TRNSYS Users,<br><br></div>I'd like to model natural convection in an Atrium. I've thus a single thermal zone, divided in 3 (vertically stacked) airnodes.<br><br></div>Now, I know I'm supposed to use coupling between these airnodes to mimic natural convection. But I'd like to have the opportunity <b>to open or close the top of my atrium</b>, depending on the temperature in the highest airnode of the atrium. For that, I'd like to use TRNFLOW. I was thinking that I'd simply connect my 3 airnodes with some very large ducts, and then connect the highest airnode to an external node, in order to model the opening/closure of the top of my atrium.<br><br></div>If I do this TRNFLOW approach, without coupling the airnodes (since the TRNFLOW approach is supposed to replace this coupling), I got an error message for the 2 "virtual ducts" in my atrium, saying "thermal airnode - no adjacent wall/window or (regime) coupling of both airnodes are defined".<br><br></div>So then I activate the coupling, but with constant zero flow rate, to avoid this message. It then crashes during the run (some message involving the inversion of a singular matrix).<br><br></div><u><b>My question is</b></u>: how are TRNFLOW and the coupling of airnodes related? What happens if I specify a coupling on one hand, and on the same time define these virtual ducts to connect my airnodes in the atrium?<br><br></div>And also, what would be the most elegant way to model this stratification, with the possibility of opening the top of my atrium? Should I use 3 separate zones instead of 3 airnodes in a single zone?<br><br></div>Thanks a lot for any suggestion!<br></div>Arnaud.<br></div>