<div dir="ltr">Hello TRNSYS users,<div><br></div><div>I've noticed that some simulations finish with  messages that say that a certain component (or components) doesn't reach convergence at certain timesteps. The message is the following:</div><div><br></div><div>" The inputs to the listed units have not converged at this timestep. The values at the last iteration will be used and the simulation will proceed."</div><div><br></div><div>Right now I'm doing a simulation with 5 min timestep that works well but gets stuck at  hour 150, for example. If I change the simulation start time everytime this happens so the simulation can continue, it keeps calculating until  it gets stuck again 200 hours later.<br><br></div><div>I assume the TRNEXE gets stuck because of non convergence. Since the non converged timesteps are neglectable, how can I set TRNSYS to automatically ignore this timesteps and set the input/ouputs of the problematic units to the previous ones?</div><div><br></div><div>Is there a chapter in the TRNSYS Documentation that I should check?</div><div><br></div><div>Thanks in advance,</div><div>Javier Vega</div></div>