<div dir="ltr">Dear all, <div><br></div><div>I have a TRNSYS model with a Type 56 building and a solar collector system attached to it.</div><div>The original model was designed in TRNSYS 16, but I have recently managed to move it to TRNSYS 17 (the relatively difficult part was to update Type 56 to TRNSYS 17).</div><div><br></div><div>When I run the model once, everything works fine. The problem starts when I do several consecutive runs (without any changes in the parameters). Sometimes the second run works perfectly as well, but on the third run the Simulation studio crashes without any warning.</div><div>The only way I found to run many times the model was deleting all the files which are generated after the previous simulation has finished. </div><div><br></div><div>Could you suggest something in order to avoid manual deleting of the output files? </div><div>My concern is than in case I would like to do a parametric run or GenOpt optimization, will I have to manually delete the output files every time?</div><div><br></div><div>Thank you in advance. </div><div>Regards, </div><div>Victor</div></div>