<div dir="ltr"><div>Hello everyone,</div><div><br></div><div>I need your help because I am taking my first steps on TRNSYS and I have a fairly complex situation to model. (Well, for a beginner like me!)<br><br></div><div>I have to model a room with the following equipment: <br>- an "air handling unit" (which collects air from the room and returns with two fans with a flow of 4000m3/h each) <br>- an duct for air inlet (flow +/- 500m3)<br>- an "suction arm" for air outlet (flow +/- 500m3 as well).<br><br></div><div>The peculiarity of this room is that we must be able to impose extreme temperatures (between -50°C and +50°C) and maintain them for a few minutes. To impose this "schedule", I have used a Type 14.<br><br></div><div>To model the AHU I try to use the Type 696, I just have some toubles trying to set it. Anyway, I have modeled the inputs and outputs of air with ducts.<br><br></div><div>The problem is that don't manage to impose the variations of temperature in the room via my AHU.<br><br></div><div>These are the connections I made:</div><div>- "Instantaneous value of function" of Type 14 to the "Heating" and "Cooling setpoint" of the type 696</div><div>- "Outlet air temp" of Type 696 to an Input of my building "T_AHU"</div><div>- "Air flow rate Dry" of Type 696 to an Input of my building "DEBIT_AHU"</div><div>- "T_AIR" of the room to "Air Inlet T°" of Type 696</div><div><br></div><div>I think my mistake may be the first connection, but I really do not see what else to do for the moment... I have not found a thermostat fitting my needs<br><br></div><div>Any help would be appreciated! Whether guiding me choosing a thermostat, on setting the Type 696, or about how to connect this component with the rest of a project ... I'm really lost!<br><br></div><div>Thanks in advance<br><br></div><div>Madeleine<br><br></div><div>PS: If this kind of question has been asked before, I sincerely apologize!</div></div>