<div dir="ltr">Hello Everyone,<div><br></div><div>I wish to modell a Trombe wall (type 36) with TRNbuld (type 56).</div><div>I have read different answers in the archives, all of them different and not so clear from my point of view.</div><div><br></div><div>My question is the following: how can I make sure that the heat fluxes and temperatures in Type 56 are the same as in Type 36?</div><div><br></div><div>For the temperature,  it is possible to define a trombe wall in TRnbuild with a type boundary (with back ceof. = 0,001 kJ/h/K/m2 and set Tboundary = Toutput 13 of Type 36 (ie = Temp of inside surface of the  trombe wall.</div><div><br></div><div>For the heat fluxes, it is also easy to implement the ventilatio heat flow in Type 56 with flos rate and Temperature of flox from ouputs 8 and 9 of Type 36.</div><div><br></div><div>Now what about the wall heat transfer from the Trombe wall to the zone? </div><div><br></div><div><br></div><div>Since the Trombe wall in Type 56 is a boundary wall it has no thermal resistance.</div><div>What about the inside loss coef. of type 36 (input .6)?</div><div><br></div><div><br></div><div>Calculations show that output from type 36 (wall heat transfer to zone) is very different from the wall heat transfer from type 56. Idem for the losses.<br></div><div><br></div><div><br></div><div>Could one use a wall surface gain instead of a boundary condition on the temperature? How to define the trombe wall in type 56 then?</div><div><br></div><div>Thank you for your help.</div><div><br></div><div>Florence Le Bail</div></div>