<div dir="ltr">I am attempting to control the surface temperature of a radiant slab by turning flow on and off through an active layer. The active layer receives a fluid of variable temperature. The allowable temperature range of the surface must be pretty small to achieve thermal comfort -- within a couple degrees.<div><br></div><div>At first I tried using a simple Type2b differential controller, where the heating setpoint is the Upper Temperature and the slab surface temperature is the Lower Temperature. However, it doesn't seem like it is responding. I do anticipate a problem with this regardless because of the thermal lag of the concrete slab. Which controller within the TESS or standard TRNSYS library would work best? Thanks.<br clear="all"><div><br></div>-- <br><div><div dir="ltr"><p style="color:rgb(136,136,136);font-size:13px;margin:0px"><font color="#073763" face="arial, helvetica, sans-serif">Brad Painting<br></font></p><p style="color:rgb(136,136,136);font-size:13px;margin:0px"><font color="#073763" face="arial, helvetica, sans-serif">Master of Science Candidate, Renewable Energy Engineering<br></font></p><p style="color:rgb(136,136,136);font-size:13px;margin:0px"><font color="#073763" face="arial, helvetica, sans-serif">Department of Technology & Environmental Design</font></p><p style="color:rgb(136,136,136);font-size:13px;margin:0px"><font color="#073763" face="arial, helvetica, sans-serif">Appalachian State University</font></p><p style="color:rgb(136,136,136);font-size:13px;margin:0px"><font color="#073763" face="arial, helvetica, sans-serif">Boone, NC  28608</font></p></div></div>
</div></div>