<div dir="ltr"><div><div><div>Sir <br></div>i have a 225 m2 five zone building model, in order to accommodate the PCM  i attached a new unconditioned zone above the building surface  <br></div>my problem is that when i change the roof of old building --to the mass less tile and at the same time i also makes the bottom of unconditioned zone by mass less tiles and top of unconditioned zone by roof boundary. (That was the roof of old building)<br><br></div>Now on simulation it requires the large amount of energy because it cant joint the top (mass less tiles BAND CELING1) and bottom of unconditioned zone(mass less tiles BAND CEILING2)<br><div><div>i think it assume the mass less tile open to sky <br><br></div><div>how these can joined or adjacent to each other <br></div><div>i am attaching the model <br></div><div>Regards <br><br></div></div></div>