<div style="line-height:1.7;color:#000000;font-size:14px;font-family:Arial"><div>Hi everyone,</div><div>I have encountered some problems when the PID controller(type23) was used for controling the outlet air temperature of cooling coil.</div><div><br></div><div>The fluid flow rate of cooling coil is conected with a outlet of flow diverter(type11), the fluid flow rate of cooling coil is determined by the control signal of the flow diverter. It is in order to model a cooling cooling with a bypass in fluid side.</div><div><br></div><div>Then, the PID control is used for keeping the outlet air temperature (Controlled variable) of cooling coil at a setpoint, the control signal is the fluid proportion of the flow diverter. </div><div><br></div><div>But no matter how to adjust the parameters of PID, the outlet air temperature oscillation cann't be eliminated.</div><div><br></div><div>so, I have two questions about this simulation.</div><div><br></div><div>1)How to determine the parameters of PID controller, sunch as Gain constant, Integral time and Derivative time, to avoid  Controlled variable oscillation ? </div><div><br></div><div>2)is there some regular between the simulation time step and the parameters ? </div><div><br></div><div>If anyone has experience in this respect, could please tell me how to choose the simulation time step and the PID parameters ?</div></div><br><br><span title="neteasefooter"><span id="netease_mail_footer"></span></span>