<!DOCTYPE html PUBLIC "-//W3C//DTD XHTML 1.0 Transitional//EN">
<html><body>
<p>Bachchulal,</p>
<p> In both Type94 and Type194 you can get two outputs for the array power. One is the power of the array if it is operating at the maximum power point. The other is the power of the array if it is operating at a particular load voltage (an input to the model). It is very rare for PV arrays to be directly connected to a load without the use of a maximum power point tracking (MPPT) device so in general, it is best to use the power (and voltage and current) outputs at the max power point. For both Type94 and Type194 these are outputs 4, 6, and 7. You can usually ignore outputs 1-3 as these are the outputs corresponding to a particular load voltage.</p>
<p>Kind regards,</p>
<p> David</p>
<p> </p>
<p> </p>
<div> </div>
<p>On 2014-06-30 04:29, Bachchulal Gupta wrote:</p>
<blockquote type="cite" style="padding-left:5px; border-left:#1010ff 2px solid; margin-left:5px"><!-- html ignored --><!-- head ignored --><!-- meta ignored -->
<div dir="ltr">
<div>
<div>
<div>
<div>
<div>
<div>dear all </div>
can u tell me in the type 94 photovoltaic panel </div>
the input load voltage is what </div>
if the voltage of a module a MPPT is 30.30V is defined in the parameter then<br /> what is the load voltage .</div>
is it inverter input voltage ? then what will be the maximun value for that the power generation is maximun.<br /><br /></div>
regards <br /><br /></div>
B.L.Gupta</div>
<br />
<pre>_______________________________________________
TRNSYS-users mailing list
<a href="mailto:TRNSYS-users@lists.onebuilding.org">TRNSYS-users@lists.onebuilding.org</a>
<a href="http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org">http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org</a>
</pre>
</blockquote>
</body></html>