1) I would use the active layer in trnsbuild.<br>2) No. It is only the heat transfer from water into room, not from "anysource" into water.<br><br><div class="gmail_quote">On 9 July 2012 13:36, Eva gklezakou <span dir="ltr"><<a href="mailto:gklezakoue@gmail.com" target="_blank">gklezakoue@gmail.com</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">Dear Sirs,<div><br></div><div>I am modelling a building with underfloor heating in many zones. First of all I do it only for one zone, after assign an active layer on the floor I connect also TYPE 114 to TYPE 56 in order to pump the water to the active layer. Also I connect Type 108 in order to control the whether the pump is on or off according to the internal temperature. If this procedure is correct I have the following questions:</div>

<div><br></div><div>1) In order to have underfloor heating to others zones do I have to connect as many TYPE 114 and 108 as the number of the zones? Each zone has its own flow rate and also the zones are separated in two groups as for the minimum temperature according to there use.</div>

<div><br></div><div>2) Does the Q sensible which is calculated include the energy which is used in order to heat up the water after each loop? I would like to compare the energy consumption of underfloor heating with that one of convective radiators.   </div>

<div><br></div><div>Thank you.</div><div><br></div><div>Regards,</div><div>Eva</div>
<br>_______________________________________________<br>
TRNSYS-users mailing list<br>
<a href="mailto:TRNSYS-users@cae.wisc.edu">TRNSYS-users@cae.wisc.edu</a><br>
<a href="https://mailman.cae.wisc.edu/listinfo/trnsys-users" target="_blank">https://mailman.cae.wisc.edu/listinfo/trnsys-users</a><br>
<br></blockquote></div><br>