<p class="MsoNormal">Dear Jeff,</p>

<p class="MsoNormal"> </p>

<p class="MsoNormal"><span lang="EN-US">I have a
few questions about type1288. </span></p>

<p class="MsoNormal"><span lang="EN-US">The first
one is related to the flow rates. Other components let users to enter the test
flow rate for a specific collector but I was surprised since this Type doesn’t
include this variable.  Why is this? How to select the best flow rate
since the one reported on the test standard report is much higher than the one
the manufacturer recommends? </span></p>

<p class="MsoNormal"><span lang="EN-US">The second
question is about the correct manner to configure a solar array of X numbers of
collector in series times Y numbers of collector in parallel. Do I have to use
a calculator in order to construct such configuration or is there another way
by using Type1288 only?</span></p>

<p class="MsoNormal"><span lang="EN-US">The third
one is about IAM for diffuse radiation. I tried to set a value of 1.015
(according to a certified report) but Trnsys got stuck and I had to use
Ctrl+Alt+Del in order to end the task. So I used a value of 1 and calculations
were performed without any problem. Do you know the reason for this problem? </span></p>

<p class="MsoNormal"><span lang="EN-US">And the
last question. What is the best way to calculate the efficiency of collectors
using the EN-12975 standard? How do I get this value in Trnsys?</span></p>

<p class="MsoNormal"><span lang="EN-US"> </span></p>

<p class="MsoNormal"><span lang="EN-US">Thank you!</span></p><div><br></div>-- <br>Andrés Montero I.<br>+34-680705256<br>