<div>Dear All, </div><div> </div><div>I am facing problem while calculating the Heat load Calculations with TRNSYS 17 version.</div><div>My quaries are</div><div> </div><div>1). How you define initial zone Temperature and Relative humdiity values. Is it </div>
<div>always fixed as 20 Degree Centigrade and 50 % RH or their is some logic /reason </div><div>behind it. </div><div> </div><div>2).While doing Heat load calculations How the values for max heat load calculations </div><div>
    like</div><div>       a). Min ambient Temperatue</div><div>       b). Room set Point Temperatue </div><div>       c) Temperature of Boundary Values</div><div>       d) Air Change rate </div><div>is set ?. I understand that the values of Min Ambient Temp is set according to the weather file/ location</div>
<div>for which the heat load calculation is to be calculated and Room set Point Temp is according to set </div><div>Point tempetaure Cooling . Pls correct  if I am wrong. What about the Temperature of Boundary</div><div>values and Air Chnage rate.How they are selected ?  pls clarify. </div>
<div> </div><div>3) when I run trnsys for calculations of heat load after setting the points at (2)  above the message </div><div>is displayed "fatal error occured in Trnsys, check listing file for errors. When I  check the </div>
<div>listing file  again second message is displayed , "not possible to edit log file as simulation</div><div>is running". </div><div>I fail to understand the above behaviour, As everything in Trnsys simulation</div>
<div>is fine and it displays the results of other outputs as asked for. </div><div> </div><div>Amit Kakkar</div><div>MTech </div><div>IIT Delhi. </div>