Hey all,<div><br></div><div>I am trying to model something in TRNSYS that may already exist as a component but I'm probably doing it the hard way. Any ideas are appreciated.</div><div><br></div><div>Basically I want to model a tempering valve that does the opposite of tempering. The tempering valve slows down the flowrate of a hot stream of water and adds the appropriate amount of cold water to be mixed in, based on a setpoint. What I am trying to do is this, I want to add the correct amount of HOT water from another source to heat up a COLD stream. Right now, I am basically using Type 11b in reverse to accomplish this by having the cold stream enter the valve, and have a tee piece mix in hot water. A "reverse" tempering valve if you will.</div>
<div><br></div><div>This seems to work, however I get the same warning at several timesteps "The inlet temperature and the heat source temperature have simultaneously exceeded the set point temperature. Gamma has been set to 0 (Mode 4) or 1 (Mode 5)"</div>
<div><br></div><div>This warning makes sense when the cold stream coming in is already over the set point and no addition of hot water is needed. I am okay with this warning as I feel that it probably doesn't affect the simulation, but I just wanted to make sure.</div>
<div><br></div><div>Also I was wondering if anyone knows of a component that is built to do this, or another way to accomplish it in a more user friendly manner that makes more sense from an engineering standpoint?</div><div>
<br></div><div>Thank you,</div><div>Nick</div>