[TRNSYS-users] Simulation stop

[David BRADLEY]

It is not uncommon for a controller to stick. That in and of itself is 
not a TRNSYS error; just a warning. If your simulation is not converging 
at a lot of time steps then you will receive a lot of warnings about non 
convergence and if it happens enough then you'll get a fatal error. Look 
in the error log and filter out all the notices and warnings so that you 
are just looking at errors. The errors are the ones that you need to 
concern yourself with.

If you are unable to find the cause of the error then you should contact 
your distributor and get help from their hotline.

kind regards,

  David


On 04/02/2020 01:35, parth prajapati via TRNSYS-users wrote:
> Hy,
>  I am working with solar water heater for domestic hot water purposes. 
> I have set simulation time for one year but analysis stops at 1344 hr. 
> In error it says that controller stuck. Please help me on this.
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20200402/2b911fdc/attachment.html>