<div dir="ltr"><font color="#0c343d">Hi Ali,</font><div><font color="#0c343d"><br></font></div><div><font color="#0c343d">As per me the LS-F report is the report which has basic load based calculation as per the building data. Whereas the BEPS is the building fuel consumption.</font></div><div><br></div><div><font color="#0c343d">I think you should not be confused with the OA being not heated as it would cause little or lesser load to the building.</font></div><div><br></div><div><font color="#0c343d">Also the LS-F report has all the components having the heating or cooling loads like occupancy, wall, roof and glass heat transfer as well as many more things.</font></div><div><font color="#0c343d"><br></font></div><div><font color="#0c343d">I think that the eQUEST is not that incapable to not to have the calculation covering the outside air.</font></div><div><font color="#0c343d"><br></font></div><div><font color="#0c343d">I think the room air is being treated as OA + supply air in the normal LS-F report.</font></div><div><font color="#0c343d"><br></font></div><div><font color="#0c343d">I don't know what sort of calculation you might have have done but the LS-F report is the basic load based calculation which are dependent on all the factors causing the heat load.</font></div><div><font color="#0c343d"><br></font></div><div><font color="#0c343d">The BEPS report might cover the water as well as air-side fuel or electricity consumption in the various end-uses.</font></div><div><font color="#660000"><br></font></div><div><font color="#660000"><b>Thanks,</b></font></div><div><font color="#783f04"><b>Sharad.Kumar</b></font></div><div><font color="#783f04"><b><br></b></font><div class="gmail_extra"><br>> On Thu, Feb 9, 2017 at 3:34 PM, via Equest-users <<br>> <a href="mailto:equest-users@lists.onebuilding.org">equest-users@lists.<wbr>onebuilding.org</a>> wrote:<br>><br>>> Hi folks,<br>>> I am using eQUEST to model electric baseboard heating with ventilation<br>>> in<br>>> a multi-story residential building. I set electric baseboards at the<br>>> zone<br>>> level, and chose packaged single zone (no heating and only baseboard) at<br>>> the system level to model the ventilation. The model runs and gives me<br>>> zero unmet hours, but the electricity consumption for baseboards is less<br>>> than what I am expecting.<br>>><br>>> The total building load in LS-F report seems to be right, and quite<br>>> aligns<br>>> with my expectation. Now, this load must be met via baseboards that are<br>>> installed in the residential units. Also, the baseboards must provide<br>>> heat<br>>> to heat up the constant running fans for the dedicated outdoor air that<br>>> I<br>>> assigned to each zone.<br>>><br>>> The electricity consumption that I get in BEPS report is only enough to<br>>> meet the building load (as reported in LS-F) but not large enough to<br>>> heat<br>>> up the OA. I did a simple hand calculation for one space during Jan, and<br>>> the values  for electricity consumption in baseboards are off by 40%.<br>>><br>>> Any thoughts on what I am doing wrong here?<br>>><br>>> P.S., for the purpose of dedicated outdoor air I set a 24/7 “ON”<br>>> schedule<br>>> for fans that blow into each unit.<br>>><br>>> Thanks for your comments<br>>> Ali Mo, EIT<br>>> Design Engineer</div><div class="gmail_extra"><br></div><div class="gmail_extra"><br></div></div></div>