<div dir="ltr"><div class="gmail_extra"><div class="gmail_quote"><div><font color="#073763">Hi Siliang,</font></div><div><font color="#073763"><br></font></div><div><font color="#073763">The Water loop set-point that you have got as may be 70 °F is the water temperature that is 21.11 °C.</font></div><div><font color="#073763"><br></font></div><div><font color="#073763">It is obvious to take set-point of the boiler below the Ground source HX as then it will operate.</font></div><div><font color="#073763"><br></font></div><div><font color="#073763">The ground source steam temperature may shoot up-to 360-370 °F.</font></div><div><font color="#073763"><br></font></div><div><font color="#073763">So may be taking steam boiler or steam plus hybrid boiler that is electricity and keeping the set-point from 180 to 230 °F can be a take.</font></div><div><font color="#073763"><br></font></div><div><span style="color:rgb(7,55,99)">One can keep the set-point of the ground water heating loop as more than 230 °F to 370 °F may be 360 °F.</span><br></div><div><font color="#073763"><br></font></div><div><font color="#073763">Then the functioning will be okay.</font></div><div><font color="#073763"><br></font></div><div><font color="#073763">Generally the boiler set-point of electrical heater is 180 °F for steam water to 230 °F which is nearly 82 °C (180 °F ).</font></div><div><font color="#0000ff"><b><br></b></font></div><div><font color="#0000ff"><b>Thanks</b></font><span style="color:rgb(7,55,99)">,</span><br></div><div><font color="#073763">Sharad.</font></div><div><font color="#073763"><br></font></div><div><br></div><div>---------- Forwarded message ----------<br></div></div>From: Siliang Lu via Equest-users <<a href="mailto:equest-users@lists.onebuilding.org" target="_blank">equest-users@lists.onebuildin<wbr>g.org</a>><br>To: "<a href="mailto:equest-users@lists.onebuilding.org" target="_blank">equest-users@lists.onebui<wbr>lding.org</a>" <<a href="mailto:equest-users@lists.onebuilding.org" target="_blank">equest-users@lists.onebuildin<wbr>g.org</a>><br>Cc: <br>Date: Sat, 6 Aug 2016 16:14:27 -0400<br>Subject: [Equest-users] Boiler temperature for hybrid geothermal heat pump system<br>Hi eQuesters,<br><br> I have a problem regarding hybrid geothermal heat pump system built in  a heating dominated building. From ASHRAE Handbook, it suggests that boiler be installed separately from geothermal heat exchanger loop due to high temperature of boiler.<br><br>In addition, one report says that even if there are some cases that boiler has to be installed into GHX loop, the setpoint shall be 5-10F lower than GHX setpoint( e.g. 45F). That is because if the boiler is installed in the GHX loop, it is likely to dump heat back into the ground if boiler setpoint is higher than GHX setpoint.<br><br> However, heat exchange is related to both temperature and flow rate. With smaller size of boiler, can we allow to install boiler with higher setpoint higher than GHX setpoint into the GHX loop? Thanks!<br><br>All the best,<br>Siliang<br></div></div>