<div dir="ltr">All,<div><br></div><div>I have a <span style="color:rgb(0,0,0);white-space:pre-wrap">series of water-to-water heat pumps that are manifolded to allow some circuits to operate in heating while others are operating in cooling, with all circuits sharing a common condenser water loop.</span></div><div><span style="color:rgb(0,0,0);white-space:pre-wrap"><br></span></div><div><span style="color:rgb(0,0,0);white-space:pre-wrap">I have created <b>two </b>2-pipe circulation loops </span><span style="color:rgb(0,0,0);white-space:pre-wrap">(one for heating and one for cooling)</span><span style="color:rgb(0,0,0);white-space:pre-wrap">, each connected to a different "Heat Pump" chiller. Both chillers are connected to my common condenser loop. For the cooling loop, I have set my snap temperature to an outdoor temperature of -20F (to ensure this loop is always in cooling mode). Conversely, I have set an outdoor snap temperature of 100F for my heating loop </span><span style="color:rgb(0,0,0);white-space:pre-wrap">(to ensure this loop is always in heating mode)</span><span style="color:rgb(0,0,0);white-space:pre-wrap">. On the air-side, I have modeled a fan coil (I have also tried SZRH) and picked the 2-pipe cooling loop for the CHW loop and the 2-pipe heating loop as the HW loop.</span></div><div><span style="color:rgb(0,0,0);white-space:pre-wrap"><br></span></div><div><font color="#000000"><span style="white-space:pre-wrap">The problem I seem to be running into is that eQuest will not allow 2 separate 2-pipe loops to operate independently and coincidentally over the entire year (i.e. I can't get one chiller to provide hot water while at the same time getting the other chiller to provide chilled water). I tried different snap temperature options, like assigning a specific zone or using a schedule loop operation (using type On/Off/TEMP) whereby I set the cooling chiller to 1 for cooling and zero for heating...and vice-versa for the heating chiller...to no avail.</span></font></div><div><font color="#000000"><span style="white-space:pre-wrap"><br></span></font></div><div><font color="#000000"><span style="white-space:pre-wrap">I previously had the model configured so that the chillers provide both heating and cooling (as in Loop-to-Loop Heat Pump)...by this is not the way the heat pumps are actually being operated.</span></font></div><div><font color="#000000"><span style="white-space:pre-wrap"><br></span></font></div><div><font color="#000000"><span style="white-space:pre-wrap">I would appreciate any suggestions/help as I've spent a lot of time trying just about everything I can think of.</span></font></div><div><font color="#000000"><span style="white-space:pre-wrap"><br></span></font></div><div><font color="#000000"><span style="white-space:pre-wrap">Thanks,</span></font></div><div><font color="#000000"><span style="white-space:pre-wrap">Chris</span></font></div></div>