Hello Everyone,<br><br>I want to change internal wall having "standard" and "adiabatic" surface type to "air" type or air type to standard type . When I do this in detailed mode for adiabatic wall to air type or air type to standard type, they do not change and standard wall changes but it  gives an Bdl error.<br>

<br>Can anyone explain me what is reason behind this.<br><br>Another,<br>I am doing a project having 2 basement and G+2 floors. A part of the upper basement is open with ground floor (means the height of the ceiling of that part is addition of basement and ground floor. I read the archives related to it, But basement's roof has no exterior exposure and when I did atrium with open to below in ground floor, it removes all the wall of ground floor's part as well as exterior wall. Again, In the archives, when increase the height of the roof but due to basement there is no exterior roof. What should I do in this condition.<br>
<br>Thanks in advance.<br><br>Regards,<br><br>Mayank Bhatnagar<br>Energy Analyst<br>