Varkie,<div><br></div><div>The first screen shot I sent shows where you can manipulate the CHW setpoint in the DD wizard.  I'm not sure about SD wizard.<br><br><div class="gmail_quote">On Thu, Dec 15, 2011 at 2:44 PM, Varkie C Thomas <span dir="ltr"><<a href="mailto:thomasv@iit.edu">thomasv@iit.edu</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
<div>Robby: This project is being done by an architect who used DD.  I looked for the error in CHW plant and forgot to look at HVAC supply temps.  I was mistaken, the Detailed Edit does allow you to set CHWS temp but not SD and DD.  Varkie<br>
<br><br>
<p></p><b>----- Original Message -----</b>
<p></p><b>From</b>: Robby Oylear <<a href="mailto:robbyoylear@gmail.com" target="_blank">robbyoylear@gmail.com</a>>
<p></p><b>Date</b>: Thursday, December 15, 2011 4:29 pm
<p></p><b>Subject</b>: Re: RE: [Equest-users] CHW error message
<div class="im"><p></p>
<p></p>> Whoops, here's the image I meant to send with the detailed edit <br>> screen:[image: image.png] <br>> <br>> On Thu, Dec 15, 2011 at 2:29 PM, Robby Oylear <br>> <<a href="mailto:robbyoylear@gmail.com" target="_blank">robbyoylear@gmail.com</a>> wrote: <br>
> <br>> > Varkie, <br>> > <br>> > On wizard screen 3 of 3 under "CHW Plant Equipment" the setpoint is <br>> > defined.  The default is 44 deg F. <br>> > <br>> > [image: image.png] <br>
> > <br>> > In detailed edit mode this setpoint can be seen on the <br>> "Circulation Loop <br>> > Properties" screen: <br>> > [image: image.png] <br>> > <br>> > On Thu, Dec 15, 2011 at 2:22 PM, Varkie C Thomas <br>
> <<a href="mailto:thomasv@iit.edu" target="_blank">thomasv@iit.edu</a>> wrote: <br>> > <br>> >> Kelsey, Robby, <br>> >> <br>> >> Thanks.  The supply air temp was too low.  What CHWS temp does <br>
> eQUEST>> assume?  This should be an input value too, besides temp <br>
 
> rise.>> <br>> >> Varkie <br></div>> >> ** <br></div>
</blockquote></div><br></div>