hi, <div><br clear="all">In one of my models, I have specified two utility meters. <div>EM1 - lighting end uses (for break up of lighting end-uses in the common areas of the building) and </div><div>EM2 - Elevators (for elevator loads)</div>

<div><br></div><div>In the EM1 I have several submeters, with different internal loads and the respective schedules. These are all ambient lighting enduses. </div>
<div><br></div><div>However the BDL file reported 2 errors. On error navigation, I was required to specify the end use again. </div><div>On doing so, the error has been resolved. The .INP entry after the resolving the errors reads thus,</div>


<div><br></div><div>Hourly Reporting</div><div><br></div><div>"EM1 Hourly Report Block" = REPORT-BLOCK </div><div>VARIABLE TYPE = "lighting end-use"</div><div>VARIABLE LIST = (1)</div><div>..</div><div>

"Hourly Report" = HOURLY-REPORT</div><div>LIBRARY ENTRY "Hourly Report"</div><div>..</div><div><br></div><div>What is REPORT BLOCK? I have never encountered this before. I dont understand how this shall affect my simulation output.</div>

<div><br></div><div>Please guide me through this.</div><div>Thanks in anticipation<br>-- <br><div>Regards,<br>Ar. Kirti Pramod Pabrekar.</div>
<div>IGBC AP, LEED India, <br>M. Arch,<br>Environmental Planning and Design.<br></div>
<div> </div>
<div><em>...Green is a commitment...not a competition...</em></div><br>
</div>
</div>