After more putzing around, i have notices that if you set the OA to 0 then you cannot humidify, so i set it to 1 cfm, and now it works...<div><br></div><div>Cooling coil is still bothering me though.<br><br><div class="gmail_quote">
On Mon, May 23, 2011 at 3:30 PM, Rob Hudson <span dir="ltr"><<a href="mailto:rdh4176@gmail.com">rdh4176@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;">
I have an Equipment Rack Room (ERR) that has a chilled water/hot water single zone system, with de-humidification and humidification.  When i try to model this, i enter in the appropriate inputs into the system and zone levels, and then for humidification i enter in my design parameters, 60% and 35% with electric cansister humidifier type.  <div>

<br></div><div>My problems begin now, when i run the model the humidifier is never turning on throughout the year, and dehumidification seems to work just fine.  Also the program is currently sizing my cooling coil to a size much larger than previously determined by hand.  </div>

<div><br></div><div>More notes:  the Rack load is 90kW with minimal other loads (lights and people).  99% sensible heat ratio.  Using this i need about 30 tons of cooling, which translates to a coil that should be slightly larger than that, due to de/humidification.  my thermastat is set to 72deg and design temperature is also 72 deg.</div>

<div><br></div><div>This has been alluding me for about 2 hours, so any help is appreciated.<br clear="all"><br>-- <br>Rob Hudson<br>
</div>
</blockquote></div><br><br clear="all"><br>-- <br>Rob Hudson<br>
</div>