<br><br>
<div class="gmail_quote">---------- Forwarded message ----------<br>From: <b class="gmail_sendername">kirti pabrekar</b> <span dir="ltr"><<a href="mailto:arkirtipabrekar@gmail.com">arkirtipabrekar@gmail.com</a>></span><br>

Date: Mon, Mar 14, 2011 at 10:38 AM<br>Subject: additions in detailed mode for ease of simulation (kirti pabrekar)<br>To: <a href="mailto:equest-users-request@lists.onebuilding.org">equest-users-request@lists.onebuilding.org</a><br>

<br><br>
<div class="gmail_quote">
<div>hi equesters, </div>
<div> </div>
<div>we have a project, that is a 38 storey tower. the tower has 4 podiums for parking above grade. A gymnasium and health club are placed over the fourth podium i have attached a rough sketch for better understanding. the typical residential floor starts above the gym level, all the way upto 37th floor. please see the sketch attached.</div>


<div> </div>
<div>I have simulated a single residential floor plate with systems, construction, loads etc. Now I need to simulate the entire building ie all the 37th residential floors and the gym level. We are considering not to simulate the podium parking levels since no mechanical systems will be provided. the only loads will be the electrical lighting loads. could this be counted as the EPD? </div>


<div> </div>
<div>Questions for further model development</div>
<div>1. how do i simulate the entire building with gym level without going into the wizard mode as we shall lose all input data. we have used floor multipliers in the parametrics and performed simulation. would this be correct result for the residential component. </div>


<div> </div>
<div>2. how do i add the gymnasium floor level to this model in the detailed mode. can i use the INP file or should i go on to create the floor by create child component way. this is a bit difficult method. was wondering if there is any easier method. i have tried to read the INP file..to check were the iterations can be made with regards to this....but it looks too complicated and i cannot understand where to pitch in my changes....any guidance on this front...</div>


<div> </div>
<div>3. Does the solar radiation considered by eQUEST at 35th floor is different that the solar radiation considered at 10 th floor. </div>
<div> </div>
<div>4. the roof of the 4th parking podium is a large landscape for the tower. where in the model do we input the exterior lighting loads and podium lighting loads. i understand that the consumption by these loads is shown as the exterior usage. </div>


<div> </div>
<div>5. how to create the energy meters in the model..and how / where to assign them...i have never tried them before, but need to get to use them now...please elaborate at extent. </div>
<div> </div>
<div>6. what are global parameters?</div>
<div> </div>
<div>7. i have realised that once the model is simulated, a half dozen more interlinked files are generated, please throw light on the significance of these....how to derive out of these files?</div>
<div><br>-- <br></div></div></div>
<div>Regards,<br>Ar. Kirti Pramod Pabrekar.</div>
<div>IGBC AP, LEED India, <br>M. Arch,<br>Environmental Planning and Design.<br>+91 9821 68 2280<br></div>
<div> </div>
<div><em>...Green is a commitment...not a competition...</em></div><br>