<span class="Apple-style-span" style="font-family: arial, sans-serif; font-size: 13px; border-collapse: collapse; ">Hello,<div><br></div><div>I'm trying to add a process load which consumes natural gas in eQUEST.  I'm doing it through the Design Development wizard.  I have enabled process loads by clicking the Process Loads box on page 15 (non-HVAC enduses to model) of the shell editor.  That enables page 21 (process loads and profiles).  In this, I can specify electric loads without a problem.  I just add in the watts per square foot and the electricity consumption goes up.  Perfect.  The trouble is the thermal loads, which are to the right of the electrical loads.  First I just tried entering 100 Btuh per square foot but left sensible fraction as zero.  Then I ran the model and there was no change.  Adding 100 Btuh per square foot has no effect on the natural gas consumption in the model.  If I try the same thing but increase the sensible fraction it will decrease the energy use in the model because it's assuming we get free heating from our process load, which is the opposite of what I want because it's assuming that process energy just magically appears in the building.  For some reason, adding a process load of X Btuh has no effect on the energy consumption.  How do I properly add this load?<br>
</div></span><br clear="all"><br>-- <br><span style="font-family:arial, sans-serif;font-size:13px;border-collapse:collapse"><font color="#888888">Adrian Gurga<br>Smart Energy Design Assistance Center<br>University of Illinois - Urbana-Champaign<br>
<a href="http://www.sedac.org/" style="color:rgb(6, 88, 181)" target="_blank">www.sedac.org</a><br>(217) 244-4671<br>(800) 214-7954</font></span><br>