<p>There is a temp keyword associated with this that triggers the supp heat when the OA is below that temp - try setting that to 0 degrees or something very low so it won't trigger the electric resistance</p>
<p><blockquote type="cite">On Aug 20, 2010 3:21 PM, "Rimes, Christie" <<a href="mailto:Christie.Rimes@wspfk.com">Christie.Rimes@wspfk.com</a>> wrote:<br><br>









<div lang="EN-US" link="blue" vlink="purple">

<div>

<p class="MsoNormal">Hi,</p>

<p class="MsoNormal"> </p>

<p class="MsoNormal">I am modeling a heat pump by using a PSZ and making the
heating type heat pump. Under the “heating” tab there is a “supp
heat/defrost” tab, where I can’t turn to “not installed”.
When running my model there is a part of the load that is being met by the supp
heating system. I have tried to increase the capacity of the heating pumps
however this doesn’t decrease the load on the supplementary system.</p>

<p class="MsoNormal"> </p>

<p class="MsoNormal">Any ideas on deleting the load and supplementary system
associated with heat pumps?</p>

<p class="MsoNormal"> </p>

<p class="MsoNormal"><img width="591" height="170" src="cid:image001.png@01CB4072.A72DB0F0" alt="Christie Rimes, 
Building Simulation Analyst
WSP Flack + Kurtz
405 Howard Street, Suite 500
San Francisco, CA 94105
Direct: 415.402.2727
Main Tel: 415.398.3833
Fax: 415.433.5311
website: http://www.wspfk.com
vCard: http://vcards.wspfk.com/vcardloader.php?filename=flackkurtz-christie-rimes-wspfk-com-1255981339.vcf
image: "></p>

<p class="MsoNormal"> </p>

</div>

</div>


</blockquote></p>