[Equest-users] Floor that is situated partly below the grade

[Grammy]

Read DOE2.2 Volume, you can build that wall separately, some underground -
you can see it in eQuest 3D view, in green color, and some part is upground.
Just cut the wall and input the accurate coordinate in detail mode.

2010/10/21 Самолётов Михаил <samoletov.mikhail at bt-comfort.ru>

>  I am modeling a two-storied building. It has one floor that is situated
> partly below the grade. Upper part of this floor lying above the grade and
> contains few windows. I have not found how to model this in eQUEST. I have
> tried to make 2 floors instead of the lower floor: one is below and other
> is above the earth surface, but then they have a ceiling between them! It is
> wrong, I think! I do not need this additional ceiling in the model.
>
>
>
> Is there anybody who speak Russian here? :)
>
>
>
> Sincerely yours,
>
> Mikhail Samoletov
>
> Chief engineer of
>
> *"Numerical Simulation Department"*
>
> *TECHNIQUE BUREAU*
>
> Cvetochnaya str, 25"Zh", 196084 St.Petersburg, Russia
>
> www.bt-comfort.ru
>
> phone/fax +7 (812) 318-50-30
>
> mob. +7 (931) 244-83-77
>
>
>
>
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20101021/3777429d/attachment.htm>