[Equest-users] (no subject) - "Use exact coordinates"

[Brian Fountain]

  Erik,

On screen 1 of the shell wizard -- select "use exact coordinates" and 
set x & y to 0 before you draw the footprint in screen 2 -- then you 
will get the alignment you are expecting.

Brian

On 10/20/2010 11:22 AM, Erik Weiss wrote:
> Every time I create floor above a floor with a large envelope (and vice versa) the floor shifts to the right. however, when i check the coordinates of the envelope vertices they are the same as like vertices in the previous floor. Is there any reason why the 3d model will show the shift?
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 9.0.862 / Virus Database: 271.1.1/3208 - Release Date: 10/20/10 02:34:00
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20101020/286b9f46/attachment.htm>