[Equest-users] Define a zone as open to below

[Udana Ratnayake]

I'm in need of placing a day light sensor to sense day light coming from the
skylights and control light level of the ground floor accordingly. even
though i make the first floor open to below the sensor doesn't seem to take
skylights in to account. is there anyway to sense the light coming from
skylights to control the lighting level with a sensor that is placed in the
floor below?

Thanx & Best Regards,
Udana.


On Sat, Nov 20, 2010 at 2:01 AM, Nick Caton <ncaton at smithboucher.com> wrote:

>  Before I was aware of ‘open to below’ and similar options in the wizards
> (oh, the perils of being self-taught!), I came up with a practice of
> creating multi-story spaces by making separate zones for each level from the
> wizard, then in detailed mode deleting all but the lowest, then modifying
> the remaining space/zone to get the correct height/volume.
>
>
>
> Some further tips:
>
> -          Once done with the geometry edits, review that space’s internal
> loads – you may want to revise depending on your situation.
>
> -          You might consider for very tall spaces whether there is an
> “unconditioned” layer from an HVAC perspective that you might want to define
> as a separate, unconditioned space (think plenum).
>
> -          You can optionally pursue extra steps to tie the bounding
> surfaces of adjacent spaces to the multi-story space if you deem it
> necessary for accuracy.  If you anticipate you’ll want to do this, pay
> attention before deleting the individual multi-story spaces so that you
> don’t accidentally remove some surfaces you’d like to have associated from
> the adjacent spaces… this is a case where thinking ahead a few steps can
> save you a headache later.
>
>
>
> ~Nick
>
>
>
> [image: cid:489575314 at 22072009-0ABB]**
>
> * *
>
> *NICK CATON, E.I.T.***
>
> PROJECT ENGINEER
>
> 25501 west valley parkway
>
> olathe ks 66061
>
> direct 913 344.0036
>
> fax 913 345.0617
>
> *Check out our new web-site @ *www.smithboucher.com* *
>
>
>
> *From:* equest-users-bounces at lists.onebuilding.org [mailto:
> equest-users-bounces at lists.onebuilding.org] *On Behalf Of *Udana Ratnayake
>
> *Sent:* Friday, November 19, 2010 1:03 AM
> *To:* equest-users at lists.onebuilding.org
> *Subject:* [Equest-users] Define a zone as open to below
>
>
>
> I'm modeling a two storied building with a mezzanine area in the first
> floor and i need to define the rest of the first floor area apart from the
> mezzanine as open to below. is it possible to define a particular zone as
> open to below in the detailed mode? if so how?
> Thank you in advance.
>
> --
> Udana
>



-- 
Udana
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20101123/f6156251/attachment.htm>