[Equest-users] Loop-to-Loop Heat-Pump

[Nicolas Mercier]

Dear eQuest User, 

 

I am currently modeling a district cooling and heating system for
provided by a ground source heat pump. 

By following the DOE 2.2 Volume 2 report, I managed to setup the system.
However I haven't been able to setup the Heating Input Ratio. 

The PV-A Plant Design Parameters gives 0 for the rated heating capacity,
any idea where to enter this parameter. 

 

 

*** PRIMARY EQUIPMENT ***                                RATED
RATED       RATED

                                                       CAPACITY
FLOW         EIR         HIR      AUXILIARY

   EQUIPMENT TYPE              ATTACHED TO             (MBTU/HR)
(GAL/MIN   )    (FRAC)      (FRAC)       (KW)

  ----------------  --------------------------------  ----------
----------  ----------  ----------  ----------

 

Heat pump                       

  LOOP-TO-LOOP-HP   CWL Coils                              2.019
481.4       0.185       0.000       0.000

                    Ground Water Loop                      2.468
548.0

                    HWL Coils                              0.000
548.0


 

Regards, 

 

NICOLAS MERCIER

Sustainability Consultant, LEED AP

HILSON MORAN

 


______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please visit http://www.messagelabs.com/email 
______________________________________________________________________
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20090729/805fa9dd/attachment.htm>