<div dir="ltr">David,<div><br></div><div>I was just looking into a very similar scenario this morning in fact. I have one question and some follow-up comments as well. </div><div><br></div><div>You stated that exception G3.1.1a can be applied, does the non-predominant conditioned space total to be at least 20,000 sf?  If so, shouldn't the residential baseline (system #1) be used for all residential units (according to Table G3.1.1A), and not system #3 as you stated? Also in this case, the whole baseline building should be fossil fuel heat source - check LI 10132 that discusses baseline heat source selection, if you're doing this for LEED. </div><div><br></div><div>The next step would be to determine the commercial space baseline, based on the floor areas of the first two levels. You might end up with System #3 or #5 depending on the total area of the commercial space. At least that's how I read "ASHRAE Interpretation IC 90.1-2007-05", you can search the quote to find the document. I'm not sure if there's anything else that supercedes that interpretation since.</div><div><br></div><div>To put it simply, if exception a applies, then I'd personally model the upper 3 floors using system #1 and the lower 2 floors with either #3 or #5 based on total commercial space area. That's how I interpreted those two referenced resources. </div><div><br></div><div>Thanks,</div><div><br></div><div> </div><div><br></div></div><div class="gmail_extra"><br><div class="gmail_quote">On Fri, Aug 26, 2016 at 1:35 PM, David BRADLEY via Bldg-sim <span dir="ltr"><<a href="mailto:bldg-sim@lists.onebuilding.org" target="_blank">bldg-sim@lists.onebuilding.org</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">Colleagues,<br>
<br>
  I am working on a 90.1 Appendix G model of a 5-story mixed-use building. The bottom two floors are commercial spaces, the top 3 floors are residential. There is an underground parking garage as well, which I have considered to be part of the residential use). The building is heated by a combination of gas and electricity; gas use predominates. By floor area the building is predominantly residential. However, about 62% of the building's total energy use is associated with the commercial parts. Because of the way that energy use breaks down I am leaning toward considering the building to be non residential, using System 5 as the baseline and taking exception G3.1.1 a (system 3) for the residential spaces. If anyone has experience with such buildings and could share their thoughts on the validity of my interpretation, I would greatly appreciate it.<br>
<br>
kind regards and my thanks in advance<br>
<br>
 David<br>
<br>
<br>
<br>
-- <br>
***************************<br>
David BRADLEY<br>
Principal<br>
Thermal Energy Systems Specialists, LLC<br>
22 North Carroll Street - suite 370<br>
Madison, WI  53703 USA<br>
<br>
P:<a href="tel:%2B1.608.274.2577" value="+16082742577" target="_blank">+1.608.274.2577</a><br>
F:<a href="tel:%2B1.608.278.1475" value="+16082781475" target="_blank">+1.608.278.1475</a><br>
<a href="mailto:d.bradley@tess-inc.com" target="_blank">d.bradley@tess-inc.com</a><br>
<br>
<a href="http://www.tess-inc.com" rel="noreferrer" target="_blank">http://www.tess-inc.com</a><br>
<a href="http://www.trnsys.com" rel="noreferrer" target="_blank">http://www.trnsys.com</a><br>
<br>
______________________________<wbr>_________________<br>
Bldg-sim mailing list<br>
<a href="http://lists.onebuilding.org/listinfo.cgi/bldg-sim-onebuilding.org" rel="noreferrer" target="_blank">http://lists.onebuilding.org/l<wbr>istinfo.cgi/bldg-sim-onebuildi<wbr>ng.org</a><br>
To unsubscribe from this mailing list send  a blank message to <a href="mailto:BLDG-SIM-UNSUBSCRIBE@ONEBUILDING.ORG" target="_blank">BLDG-SIM-UNSUBSCRIBE@ONEBUILDI<wbr>NG.ORG</a><br>
</blockquote></div><br></div>